[. . . ] Take the following precautions to prevent fire and avoid personal injury : · check that no metal objects (coins , tools , etc. ⷠIf you smell or see smoke, turn the power off immediately and consult your Kenwood dealer. Be sure to use round shape CDs only for this unit and do not use any special shape CDs. Take the following precautions to keep the unit in proper working order. [. . . ] ⷠDo not install the unit in places it is exposed to direct sunlight, high heat or humidity, water may splash over it, or dust exists. If the unit is installed at a dusty place, dust accumulates inside the unit and unit may be damaged. ⷠWhen drilling a hole in the car to fix the brackets, make sure not to damage the fuel tank, brake tube, wiring harnesses, etc. If the unit is installed near speakers, the speakers vibration may causes a sound skip. ⷠBe sure to use CDs with disc mark only for this unit. ⷠCD-Rs and CD-RWs which have not undergone finalization processing cannot be played. (For more information on finalization processing, refer to the manual for your CD-R/CD-RW writing software or CD-R/CD-RW recorder. ) Additionally, depending on the recording status, it may prove impossible to play certain CDs recorded on CD-R or CD-RW. Using such a CD may cause the CD to be deformed and the sticker to peel off, resulting in malfunction of the unit. If you have difficulty in installing this unit in your vehicle, contact your Kenwood dealer. Do not store discs where they will be exposed to direct sunlight (such as on the seat and dashboard) or high heat. A CD-R or CD-RW is more susceptible than a music CD to damage from high temperatures and humidity, and in some cases, may become unusable if left in the car for long periods of time. ⷠIf you do not use your unit for an extended time, remove the discs from the unit and put them in their cases. Do not leave them lying around without cases, piled up, or leaning on a wall and so on. ⷠIf you attach an adapter to an 8 cm (3") compact disc and load it into this unit, the adapter may be detached from the disc, causing damage to the unit. 2CAUTION · Take care to insert trays into the correct grooves in the disc magazine and to insert discs properly into the tray grooves. ⷠInsert all trays even when some of them do not carry discs. Use the CD changer with its door closed to prevent the entry of dust into the changer. If the door is not completely open, the magazine may hit the door and cause damage of malfunction. After removing the transport screw, retain it carefully and attach it again before transporting the unit again. [. . . ] After removing the transport screw, retain it carefully and attach it again before transporting the unit again. 2 Angle adjustment switches · The angle adjustment switches on the both side of the unit are to be set according to the angle of installation of the CD auto changer. If the switches are not set properly, sound skip or other malfunction may occur. ⷠSet the angle adjustment switches with a coin or other flat object. [. . . ]